If you follow my FB page then you’ve already seen this gorgeous set of paper flowers that stood in the center of a baptism reception. Please visit and LIKE my page to receive project updates!
This set was done in the same fashion as my previous displays. However, I started cutting the displays in half which makes for easier transport and set up. They come together on the stand and look seamless 👍
This display includes the spray painted roses that I shared earlier this week. Please watch the video in this post to see how I went about that.
Thank you for visiting my crafty page! I appreciate all of you 😍
My original paper flower layout was pink, white, and gold. This is the same layout with gray! I LOVE IT 💜 The different types of flowers and petal sizes absolutely work together. This was for a baby shower. Please LIKE and SHARE this blog post!
My friends! I’m sharing an awesome set of paper flowers I made for a wedding table backdrop. I adore this bold combo of colors! It’s the same design as the last pink and gold set, but just different colors. Makes it look totally different!
So sweet! The table was used to hold bouquets, card box, bubbles, and the Polaroid for everyone to take a picture in front of the flowers. The pictures were added to cardstock for the guests to sign next to their pictures. Such an adorable idea!
The following pictures show the back of the stand. Even though it’s not what clients see, it’s still important to keep it neat back there.
Introducing my new feet! The previous ones seen in my diy stand video were too long. They were easily tripped on if clients removed the table and used the backdrop for pictures. Even in the Ninjago backdrop pictures you could see the legs extend past the table. No bueno! Now with these shorter bad boys, the stand is still sturdy and versatile.
Here’s one I know most of you are curious about. The flowers are not pinned to the curtain. They droop and face down when they’re pinned. So, I hot glue them to a foam board that’s cut to the right shape. When the white curtain is behind it all, you don’t even notice the foam board! . . . The foam board is hanging on the bottom of the stand in this picture just while I organize and adhere the flowers. Once I’m done it goes to the top half of the stand.
That’s that, folks! I hope you enjoyed today’s late night post. Until the next project ❤
Don’t forget to like and share my FB page! I appreciate everyone that has done so.
It’s a Lego #Ninjago Birthday Party!!! If you follow my Facebook page then you’ve seen the teasers I’ve been leaving 😉
I used the 6x7ft PVC stand I put together. Purchased 3 yards of Walmart’s basic polyester fabric and sewed each end to fit around the pipe. The Ninjago eyes are cut from a basic yellow poster and the eyes are cut from black felt. They’re sticking onto the fabric with Velcro. I, of course, put in a few stitches in each Velcro square to secure it onto the fabric.
CRICUT TIP: I googled Ninjago eyes HD to get a cleaner JPEG image. Directly under the search bar click on TOOLS then SIZE appears under that. Click on LARGE. Right click and “save image as” a picture that has high-resolution (1000+). When you feed this into #CricutDesignSpace it will clean up very nicely. It will give you amazingly cleaner edges than a regular image grab.
I watched a few dozen videos on YouTube to figure out the balloon columns. There isn’t another PVC pipe in there! It’s all held together with curling ribbon. It’s very sturdy!
The banner above only says “birthday” because the table directly to the left says “happy”.
Hope y’all enjoy today’s share! Don’t forget to get on my Facebook page where you’ll see bonus pictures/videos 👍
I’m sharing the most adorable pink and gold banner for a baby girls 1st birthday! Each pendant measures 4x6in. I used full size craft foam for sturdy dimension. The dimensional bows at each end have loops behind them for hanging.
I love how this turned out!!! Please enjoy 🤗 Don’t forget to join my Facebook Page for bonus creations and videos.