It’s a Lego #Ninjago Birthday Party!!! If you follow my Facebook page then you’ve seen the teasers I’ve been leaving 😉
I used the 6x7ft PVC stand I put together. Purchased 3 yards of Walmart’s basic polyester fabric and sewed each end to fit around the pipe. The Ninjago eyes are cut from a basic yellow poster and the eyes are cut from black felt. They’re sticking onto the fabric with Velcro. I, of course, put in a few stitches in each Velcro square to secure it onto the fabric.
CRICUT TIP: I googled Ninjago eyes HD to get a cleaner JPEG image. Directly under the search bar click on TOOLS then SIZE appears under that. Click on LARGE. Right click and “save image as” a picture that has high-resolution (1000+). When you feed this into #CricutDesignSpace it will clean up very nicely. It will give you amazingly cleaner edges than a regular image grab.
I watched a few dozen videos on YouTube to figure out the balloon columns. There isn’t another PVC pipe in there! It’s all held together with curling ribbon. It’s very sturdy!
The banner above only says “birthday” because the table directly to the left says “happy”.
Hope y’all enjoy today’s share! Don’t forget to get on my Facebook page where you’ll see bonus pictures/videos 👍